arrow
返回

2.5D finite element algorithm based on Drucker-Prager yield criterion

delete2024-06-01
delete0
PRE
AI
M
Meng Gao *
L
Luao Fan
高
高广运 (Guangyun Gao)
DOI:10.1016/j.soildyn.2024.108676delete
delete原文链接
delete原文求助
delete分享
delete收藏
摘要

摘要

En 中文
This note regards the embankment as an ideal elastic -plastic material, and introduces the Drucker -Prager yield criterion into 2.5-D FEM. Firstly, the pure elastic trial stress is applied, and the Drucker -Prager yield criterion is used to determine whether yielding will occur or not. Then, the backward Euler integration method and the tangent stiffness method are used to derive the consistent tangent modulus matrix, after which the iterative correction of plastic deformation is realized. Finally, an elastoplastic 2.5D FEM is proposed according to the procedures. Compared with the measured values and existing results, it was found that the elastic -plastic 2.5-D finite element algorithm proposed in this note has good consistency with the measured values. Due to the consideration of the plastic deformation of the foundation soil induced by train moving loads, the present results are slightly larger than those of existing elastic methods.
Keyword:
Drucker-Prager yield criterion
Elastic-plastic
2.5-D FEM
Tangent stiffness method

期刊

Soil Dynamics and Earthquake Engineering 封面图
Soil Dynamics and Earthquake Engineering
IF:
4.6
论文数:
7.7K
被引数:
2.5W

机构

T
tongji university
学者数:
7.9W
论文数: 6.0W
被引数: 98
引用论文

引用论文

err分享
err收藏
err分享
err收藏
没有更多内容