返回
A displacement-controlled arc-length solution scheme
DOI:10.1016/j.compstruc.2021.106674.png)
摘要
En 中文
Tracing load-displacement paths in structural mechanics problems is complicated in the presence of critical points of instability where conventional load-or displacement control fails. To deal with this, arc-length methods have been developed since the 1970s, where control is taken over increments of load at these critical points, to allow full transit of the load-displacement path. However, despite their wide use and incorporation into commercial finite element software, conventional arc-length methods still struggle to cope with non-zero displacement constraints. In this paper we present a new displacement-controlled arc-length method that overcomes these shortcomings through a novel scheme of constraints on displacements and reaction forces. The new method is presented in a variety of serving suggestions, and is validated here on six very challenging problems involving truss and continuum finite elements. Despite this paper's focus on structural mechanics, the new procedure can be applied to any problems that involve nonhomogeneous Dirichlet constraints and challenging equilibrium paths. (c) 2021 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http:// creativecommons.org/licenses/by/4.0/).
Keyword:
Non-linear solvers
Arc-length methods
Boundary conditions
Displacement control
Large deformation mechanics
Snap-back
through
期刊
C
IF:
4.8
论文数:
6.2K
被引数:
1.7W
机构
引用论文
Multicenter Experience with Nonischemic Multiport Laparoscopic and Laparoendoscopic Single-Site Partial Nephrectomy Utilizing Bipolar Radiofrequency Ablation Coagulator多中心经验:采用双极射频凝固器进行非缺血多孔腹腔镜及经腹腹内镜单孔部分肾切除术
On the Influence of Flame-Retardant Additives on UV-Curable Thermosetting Glass Fiber-Reinforced Composites
Polymers
IF0

