.png){kind=icon}
返回
A Model Predictive Contouring Error Precompensation Method
.png){kind=icon}
PRE
AI
DOI：10.1109/TIE.2019.2921294.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Contouring error has a significant effect on machining accuracy. In this paper, a model predictive contouring error precompensation method is presented that performs model-based error precompensation with feedback and constraints. The proposed method uses the predicted contouring error without compensation obtained by simulation, as the reference trajectory of the model predictive compensator. It then calculates the compensation signal using a constrained model predictive control algorithm and adds it to the original reference position as the new system input. Experiments were conducted on an X-Y table to compare the proposed method with a traditional cascaded proportional-integral (PI) controller and two existing contouring error precompensation methods. The experimental results show that higher contouring accuracy can be achieved with the proposed method for both sharp corners and free-form curves.
Keyword:
Predictive models
Mathematical model
Error compensation
Machining
Modeling
Closed loop systems
Mechanical systems
Computer numerical control (CNC)
contouring control
error compensation
model predictive control (MPC)
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
7.2
论文数:
1.8W
被引数:
9.8W
机构
引用论文
.png){kind=icon}
查看更多内容