.png){kind=icon}
返回
A new algorithm for calculating utility harmonic impedance
.png){kind=icon}
PRE
AI
DOI：10.1016/j.epsr.2020.106893.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
In engineering, it is very valuable to estimate the utility harmonic impedance of a point of common coupling (PCC). However, the existing methods usually assume that the customer harmonic impedance is much larger than the utility harmonic impedance, if not, the estimated accuracy is hard to meet engineering requirement. Unfortunately, in modern power grid, due to the influence of filters or reactive compensation capacitors installed on the customer side of a PCC, the above assumption is no longer valid. This paper proposes a new algorithm to overcome this problem, the proposed algorithm can get a fairly good estimated result while the amplitude of utility harmonic impedance is approximately equal to the customer harmonic impedance. In this algorithm, firstly, the amplitude of utility harmonic impedance is calculated by using the weak correlation of the fluctuation of the harmonic sources on both sides of a PCC, and the impedance angle can be obtained through minimizing background harmonic fluctuation energy. Simulation and field case verify the effectiveness.
Keyword:
Harmonic impedance
Weak correlation
Fluctuation energy
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
4.2
论文数:
1.2W
被引数:
2.2W
机构
引用论文
.png){kind=icon}
Method based on independent component analysis for harmonic extraction from power system signals
PREAI
分享收藏分享收藏
查看更多内容