.png){kind=icon}
返回
A Reflection Coefficient Estimation Method for Power Cable Defects Based on Three-Point Interpolated FFT
.png){kind=icon}
PRE
AI
DOI：10.1109/TIM.2023.3343831.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
The reflection coefficient of reflected wave is one of the most important parameters to characterize the damage degree of power cable defect. However, due to the attenuation and the crossing coupling among the reflection coefficients of each defect, the reflection coefficient of the reflected wave can be hardly estimated, resulting in inaccurate power cable fault diagnosis. Thus, a method based on three-point interpolation fast Fourier transform (FFT) to estimate the reflected amplitude of cable defects is proposed. First, three adjacent points on each spectral peak in the frequency domain are selected to accurately analyze the exponential signal in the frequency domain and gain the parameters, including the amplitude and phase of the reflected wave at the defect. Then, the state of the defect is evaluated by the reflection coefficient at the defect. Finally, the simulation result shows that both the amplitude and phase relative errors of the proposed method are less than 10%; meanwhile, the experiment results prove that the proposed method can accurately judge the state of the cable defect.
Keyword:
Reflection
Reflection coefficient
Power cables
Frequency-domain analysis
Couplings
Capacitance
Attenuation
Cable defects
frequency-domain reflection (FDR)
reflection coefficient
three-point interpolated FFT
期刊
IF:
5.9
论文数:
2.0W
被引数:
5.8W
机构
引用论文
.png){kind=icon}
Condition Assessment of I&C Cables in Nuclear Power Plants via Stepped-Frequency Waveform Reflectometry基于步进频率波形反射法的核电站I & C电缆状态评估
PREAI
分享收藏A Frequency Sweep Location Method for Soft Faults of Power Cables Based on MUSIC-Pseudospectrum
PREAI
分享收藏A Novel Dampness Diagnosis Method for Distribution Power Cables Based on Time-Frequency Domain Conversion基于时频域转换的配电电缆受潮诊断新方法
PREAI
分享收藏
查看更多内容