返回
A Stroke Estimation Method for Linear Oscillatory Machine Using an Improved Sliding Mode Observer
DOI:10.1109/TIA.2022.3193653.png)
摘要
En 中文
For the linear compressor system driven by a linear oscillatory machine (LOM), the piston stroke is very important to realize the high working efficiency for the whole system. In order to obtain precise and reliable piston stroke signals without using the position sensor, this article proposes a stroke estimation method for the LOM using an improved sliding mode observer (SMO). For the improved SMO, the integral sliding surface is chosen to reduce the chattering phenomenon and the steady-state error of the system, and a novel reaching law is introduced to construct the sliding control law, which can further reduce the influence of the sliding chattering. Due to the piston stroke being obtained by integrating the back electromotive force (EMF) as estimated by the improved SMO, the pure integration saturation problem will occur due to that the measured current and voltage signals always contain some dc components. In order to cope with this problem, a self-adaptive bandpass filter is designed, which can obtain a filtered signal with almost no amplitude and phase deviation by adaptively adjusting its center frequency. Simulation and experimental results confirm that the proposed improved SMO has higher stroke estimation accuracy than the back EMF integration and the conventional SMO.
Keyword:
Linear oscillatory machine (LOM)
piston stroke
pure integral saturation
self-adaptive band-pass filter (SABPF)
sliding mode observer (SMO)
期刊
IF:
4.5
论文数:
1.1W
被引数:
3.5W
机构
引用论文
Improved Continuous Fast Terminal Sliding Mode Control With Extended State Observer for Speed Regulation of PMSM Drive System基于扩张状态观测器的PMSM调速系统改进连续快速终端滑模控制
A Novel Robust Super-Twisting Nonsingular Terminal Sliding Mode Controller for Permanent Magnet Linear Synchronous Motors永磁直线同步电机的新型鲁棒超扭非奇异终端滑模控制器

