Continuous liquid interface production of 3D objects

doi:10.1126/science.aaa2397

Continuous liquid interface production of 3D objects

2015-03-20

0

OA

AI

DOI：10.1126/science.aaa2397

原文链接

查看原文

摘要

En 中文

Fast, continuous, 3D printing Although three-dimensional (3D) printing is now possible using relatively small and low-cost machines, it is still a fairly slow process. This is because 3D printers require a series of steps to cure, replenish, and reposition themselves for each additive cycle. Tumbleston et al. devised a process to effectively grow solid structures out of a liquid bath. The key to the process is the creation of an oxygen-containing “dead zone” between the solid part and the liquid precursor where solidification cannot occur. The precursor liquid is then renewed by the upward movement of the growing solid part. This approach made structures tens of centimeters in size that could contain features with a resolution below 100 µm. Science , this issue p. 1349

Continuous liquid interface production of 3D objects

摘要

AI总结

期刊

机构

引用论文