.png){kind=icon}
返回
Converting point-wise nuclear cross sections to pole representation using regularized vector fitting
.png){kind=icon}
OA
AI
DOI：10.1016/j.cpc.2017.12.004.png)
.png){kind=icon}
.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Direct Doppler broadening of nuclear cross sections in Monte Carlo codes has been widely sought for coupled reactor simulations. One recent approach proposed analytical broadening using a pole representation of the commonly used resonance models and the introduction of a local windowing scheme to improve performance (Hwang, 1987; Forget et al., 2014; Josey et al., 2015, 2016). This pole representation has been achieved in the past by converting resonance parameters in the evaluation nuclear data library into poles and residues. However, cross sections of some isotopes are only provided as point-wise data in ENDF/B-VII.1 library. To convert these isotopes to pole representation, a recent approach has been proposed using the relaxed vector fitting (RVF) algorithm (Gustavsen and Semlyen, 1999; Gustavsen, 2006; Liu et al., 2018). This approach however needs to specify ahead of time the number of poles. This article addresses this issue by adding a poles and residues filtering step to the RVF procedure. This regularized VF (ReV-Fit) algorithm is shown to efficiently converge the poles close to the physical ones, eliminating most of the superfluous poles, and thus enabling the conversion of point-wise nuclear cross sections. (C) 2017 Elsevier B.V. All rights reserved.
Keyword:
Nuclear cross sections
Pole representation
Doppler broadening
Vector fitting
ReV-Fit
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3.4
论文数:
1.2W
被引数:
3.7W
机构
暂无机构信息
引用论文
.png){kind=icon}
查看更多内容