.png){kind=icon}
返回
Current-Transformer Saturation Prevention Using a Controlled Voltage-Source Compensator
.png){kind=icon}
PRE
AI
DOI：10.1109/TPWRD.2016.2580585.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Current-transformer (CT) saturation causes severe distortion in the measured current waveform which may lead to maloperation of the protective devices. This paper proposes a low-cost, power-electronic device to prevent the CT from saturation. The proposed compensator is inserted in series with the relay in the CT secondary circuit and acts as a controlled voltage source (CVS). The proposed CVS generates a time-varying voltage to cancel the voltage developed across the CT burden; therefore, the CT magnetic flux remains almost constant and undistorted during the power system transients. It will be shown that this device can precisely compensate fault current, inrush current, and other probable transient currents despite its simplicity. The proposed device can be employed to compensate the already in-service CTs connected to nondigital and digital relays. Comprehensive computer simulations are carried out to validate the effectiveness of the proposed compensator. The performance of a sample compensator of this type is validated through special high-current laboratory experiments (carried out over several hundred amperes up to 1.6 kA), and the obtained results illustrate the capability of the proposed compensator to prevent CT saturation.
Keyword:
Current transformer (CT)
CT compensation
CT saturation
hardware-based compensator
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3.7
论文数:
9.1K
被引数:
2.2W
机构
引用论文
分享收藏Low-Cost Prototype for the Electronically Compensation of Current Transformers.png)
IEEE SENSORS JOURNAL
IEEE SENSORS JOURNALIF4.5
PREAI
分享收藏
查看更多内容