Damage detection in composite materials using Lamb wave methods

doi:10.1088/0964-1726/11/2/310

Damage detection in composite materials using Lamb wave methods

2002-04-05

686

OA

AI

DOI：10.1088/0964-1726/11/2/310

原文链接

原文求助

摘要

En 中文

Cost-effective and reliable damage detection is critical for the utilization of composite materials. This paper presents part of an experimental and analytical survey of candidate methods for in situ damage detection of composite materials. Experimental results are presented for the application of Lamb wave techniques to quasi-isotropic graphite/epoxy test specimens containing representative damage modes, including delamination, transverse ply cracks and through-holes. Linear wave scans were performed on narrow laminated specimens and sandwich beams with various cores by monitoring the transmitted waves with piezoceramic sensors. Optimal actuator and sensor configurations were devised through experimentation, and various types of driving signal were explored. These experiments provided a procedure capable of easily and accurately determining the time of flight of a Lamb wave pulse between an actuator and sensor. Lamb wave techniques provide more information about damage presence and severity than previously tested methods (frequency response techniques), and provide the possibility of determining damage location due to their local response nature. These methods may prove suitable for structural health monitoring applications since the travel long distances and can be applied with conformable piezoelectric actuators and sensors that require little power. (Some figures in this article are in colour only in the electronic version).

Keyword:

SENSORS

Damage detection in composite materials using Lamb wave methods

摘要

期刊

机构

引用论文