返回
Design of Electromagnetic Actuators Using Layout Optimization With Distributed Current Source Models
DOI:10.1109/TMECH.2015.2404031.png)
摘要
En 中文
This paper presents a layout optimization method for maximizing the torque-to-weight ratio of an electromagnetic actuator. Layout optimization, which focuses on finding practical designs to maximize output performance in a compact design, avoids nonlinearity and local convergence problems in the optimization of the electromagnetic system using two sequential steps; linear topology optimization and integer programming. Formulated in terms of decomposed volume and surface elements with equivalent current sources, the linear topology optimization optimizes the permanent magnet material distribution in the rotor. With the linearly optimized designs, integer programming determines the most preferred design in the second step by evaluating performances over design complexity. As illustrations, the method is applied to maximize the torque performance of two different three-phase disk-shaped synchronous motors. The effects of two different current waveforms, sinusoidal and square wave, on the torque magnitude and ripple are considered in the optimization. The design method has been experimentally validated by comparing simulated results of the layout optimization with measured magnetic field and torque output. This component-wise method that maximizes the net force/torque averaged over various orientations represents an improvement over existing algorithms where topology optimization is conducted at a specific rotor orientation to reduce the computational cost.
Keyword:
Actuator design
electromagnetic motor
integer programming
rotor material optimization
topology optimization
torque maximization
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
I
IF:
7.3
论文数:
5.5K
被引数:
2.4W
机构
引用论文
Influence of operating conditions on the efficiency of domestic wastewater treatment in membrane bioreactors
Desalination
IF0

