返回
Differential Pressure-Based Densitometer in Dynamic Condition
DOI:10.1109/TIM.2020.3011783.png)
摘要
En 中文
Change in density will cause errors in measurement for indirect-based level sensing approaches, such as capacitive sensors. In addition, there is growing attention in measuring density accurately not only in laboratory conditions but also in a real-time dynamic environment. To address the above-mentioned issues, an independent instrument based on differential pressure sensors is proposed in this article. Synchronous detection is used to detect the desired signal by calculating the coefficients of the digital Fourier transform. The characterization of the sensor is experimentally determined under a steady-state condition, where a linear response is observed. The thermal behavior of the proposed sensor is studied and compensated using the polynomial fitting technique. Evaluating the uncertainty due to reference values, linearity, and repeatability, the obtained results show a combined uncertainty lower than 7.5 (mg/cm(3)), mainly limited by observed asymmetric hysteresis at higher temperatures.
Keyword:
Density measurement
DFT
differential pressure (DP)
phase-sensitive detention
temperature variation
uncertainty
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
5.9
论文数:
2.0W
被引数:
5.8W
机构
引用论文
Les programmes de français et l’enseignement de la littérature : ruptures et continuités depuis 1995

