.png){kind=icon}
返回
Double active transient thermography
.png){kind=icon}
OA
AI
DOI：10.1016/j.ndteint.2021.102566.png)
.png){kind=icon}
.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
This paper presents an innovative variant of the Active Transient Thermography (ATT), designated Double Active Transient Thermography (DATT), where the component inspected is excited by one heat and one cold sources. The goal is to speed up and improve the temperature contrast, namely for polymer matrix composites parts produced by Additive Manufacturing. Finite element analysis of the thermal phenomena involved in DATT were performed to assist the definition of the experimental set-ups and confirm the high potential of the technique. Experimental results prove that the introduction of the cold flow increases the temperature contrast up to 100%, comparing with ATT, and mid thickness defects are the ones that benefits the most from this technique. Therefore, the improvement of the inspection procedure is achieved by two means: enhancing the thermal contrast of the defects, and/or anticipating the instant when the maximum contrasts occur.
Keyword:
Active transient thermography
DATT
Polymer matrix composites
Simulation
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
N
IF:
4.5
论文数:
3.1K
被引数:
9.0K
机构
引用论文
分享收藏Effect of layer orientation on mechanical properties of rapid prototyped samples层取向对快速成型样品力学性能的影响
PREAI
分享收藏Continuous wave terahertz imaging for NDT: Fundamentals and experimental validation无损检测的连续波太赫兹成像: 基本原理和实验验证.png)
MEASUREMENT
MEASUREMENTIF5.6
PREAI
分享收藏
查看更多内容