.png){kind=icon}
.png){kind=icon}
Return
Effects of hot isostatic pressing and internal porosity on the performance of selective laser melted AlSi10Mg alloys
.png){kind=icon}
PRE
AI
T
T
T
DOI：10.1016/j.msea.2019.138713.png)
.png){kind=icon}
Original request for help.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
We herein report the preparation of AlSi10Mg alloys with a range of porosities by selective laser melting (SLM) and subsequent hot isostatic pressing (HIP). The microstructures and mechanical properties of the resulting alloys were then investigated, and the influence of the internal porosity on the mechanical properties was investigated. Under the optimum laser irradiation conditions, the tensile strength of the alloy was very high; however, this tensile strength decreased with increasing the internal porosity. Following HIP, both the proof and tensile strengths decreased significantly due to drastic changes in the microstructures, i.e., the fine dendritic cell microstructure changed to granular precipitated Si phases. In addition, the initial porosity had a relatively small effect on the proof and tensile strengths and these strengths were comparable for all materials. In contrast, the ductility of the alloy improved significantly after HIP; however, it deteriorated as the initial porosity was increased. This was accounted for by the fact that HIP treatment was not really effective for eliminating the internal pores in the SLM AlSi10Mg alloy. Therefore, the reduction of internal pores by the optimization of laser irradiation conditions is essential in the fabrication of SLM aluminum alloys.
Keywords:
Additive manufacturing (AM)
Selective laser melting (SLM)
Aluminum alloy
Internal porosity
Hot isostatic pressing (HIP)
AI Summary
Key information extracted from the uploaded paper, including a brief overview, abstract, background, key highlights, visual analysis, and future outlook.
Journal
M
IF:
7
Papers:
3.7W
Citations:
13.8W
Organization
No organization information available
Cited Papers