Fast Electrical Impedance Tomography Based on Code-Division-Multiplexing Using Orthogonal Codes

doi:10.1109/TIM.2015.2410310

2015-05-01

PRE

DOI：10.1109/TIM.2015.2410310

原文链接

原文求助

摘要

En 中文

Electrical impedance tomography (EIT) is used to determine the spatial conductivity distribution of a measurement environment that involves several applications in the areas of process engineering and medical diagnostics. In common EIT systems, the measurements are performed by means of current patterns which are injected into the measurement environment using a serial time-division-multiplexing (TDM) scheme for the excitation of different electrodes. The measurement rate can be increased by performing parallel excitation using orthogonal signals. In this paper, a code-division-multiplexing (CDM) measurement procedure is presented. To optimize the separation between different measurement channels and the dynamic range, orthogonal Walsh-Hadamard codes are used. The measurements are conducted with a fast EIT system with nine parallel excitation sources and 18 parallel measurement channels. The measured crosstalk rejection between different channels is larger than 98 dB. The maximum absolute deviation between different measurement sets for repeated measurements is less than 24 mu V with a mean standard deviation of less than 8.2 mu V. The dynamic range for impedance measurements based on different excitation procedures (TDM, frequency-division-multiplexing, and CDM) has been determined. Furthermore, reconstructed conductivity distributions based on measurements with the different excitation procedures have been compared with each other for different measurement scenarios (a root mean square difference of less than 1.2%). Finally, the influences of frequency-dependent measurement objects on the excitation procedures have been discussed.

Keyword:

Code-division-multiplexing (CDM)

codes

electrical impedance tomography (EIT)

frequency-division-multiplexing (FDM)

tomography