Function-oriented method for the definition and verification of microstructured surfaces

Albert Weckenmann

doi:10.1016/j.precisioneng.2013.01.013

Function-oriented method for the definition and verification of microstructured surfaces

2013-07-01

25

PRE

AI

DOI：10.1016/j.precisioneng.2013.01.013

原文链接

原文求助

摘要

En 中文

Currently available measurement techniques enable high-resolution topography and structural measurements down to the subnanometer range. Nevertheless, in many cases despite extensive geometric data of the manufactured, real workpiece it is not possible to make a clear statement about the functional ability, because conventional concepts of tolerancing are solely geometry-oriented and standardized surface parameters are not sufficient or even missing completely for characterizing the degree of ability to fulfil a function. To define and determine appropriate parameters characterizing the functional behaviour, a method was developed based upon a parameterized mathematical-physical model of the function. From this model function-related properties can be identified and geometric parameters can be derived, which can be different for the manufacturing and the verification process. With this method it is possible to optimise the definition of the shape of the workpiece regarding the intended function by applying theoretical and experimental knowledge as well as modelling and simulation. Especially for the verification process of functional microstructures a model-based testing has benefits: Using the model like a kind of virtual functional gauge imprecise standardized definitions and measurement evaluations can be omitted, while the functional ability is getting quantitatively predictable. The exchange of information of the complex process chain from defining functional requirements, designing and dimensioning taking into regard the manufacturing process up to testing conformance and verification functional ability is increased. Focussing attention on a function oriented conformity decision, development priorities can be separated better and processes are getting more objective and transparent. Advantages of this approach for the design process, the manufacturing process and verification process will be discussed and demonstrated by the example of a microstructured inking roll. (C) 2013 Elsevier Inc. All rights reserved.

Keyword:

Function-oriented

Product development

Microstructured surfaces

Surface metrology

Anilox inking roll

Model-based test technique

Function-oriented method for the definition and verification of microstructured surfaces

摘要

期刊

机构

引用论文