Fuzzy classifier identification using decision tree and multiobjective evolutionary algorithms

Pulkkinen, Pletarl

doi:10.1016/j.ijar.2007.10.004

2008-06-01

PRE

Pulkkinen, Pletarl *

Hannu Koivisto

DOI：10.1016/j.ijar.2007.10.004

原文链接

原文求助

摘要

En 中文

This paper presents a hybrid method for identification of Pareto-optimal fuzzy classifiers (FCs). In contrast to many existing methods, the initial population for multiobjective evolutionary algorithms (MOEAs) is neither created randomly nor a priori knowledge is required. Instead, it is created by the proposed two-step initialization method. First, a decision tree (DT) created by C4.5 algorithm is transformed into an FC. Therefore, relevant variables are selected and initial partition of input space is performed. Then, the rest of the population is created by randomly replacing some parameters of the initial FC, such that, the initial population is widely spread. That improves the convergence of MOEAs into the correct Pareto front. The initial population is optimized by NSGA-II algorithm and a set of Pareto-optimal FCs representing the trade-off between accuracy and interpretability is obtained. The method does not require any a priori knowledge of the number of fuzzy sets, distribution of fuzzy sets or the number of relevant variables. They are all determined by it. Performance of the obtained FCs is validated by six benchmark data sets from the literature. The obtained results are compared to a recently published paper [H. Ishibuchi, Y. Nojima, Analysis of interpretability-accuracy tradeoff of fuzzy systems by multiobjective fuzzy genetics-based machine learning, International Journal of Approximate Reasoning 44 (1) (2007) 4-31] and the benefits of our method are clearly shown. (C) 2007 Elsevier Inc. All rights reserved.

Keyword:

fuzzy classifiers (FCs)

multiobjective evolutionary algorithms (MOEAs)

decision trees (DTs)

initialization