返回
Grain refinement in γ-TiAl-based alloys by solid state phase transformations
DOI:10.1016/j.intermet.2005.11.015.png)
摘要
En 中文
The colony size of a fully lamellar Ti-46Al-2Cr-2Mo-0.25Si-0.3B ingot was refined from 120 to 30-65 mu m by well defined heat-treatments which exploit the suppression of the alpha -> alpha + gamma transformation or involve cyclic annealing around the alpha-transus temperature. In addition, an extremely fine lamellar spacing in the range of 30-40 nm was obtained. For coarse-grained fully lamellar Ti-46Al-9Nb a massive phase transformation was used for microstructural refinement. The thermal stability of the massively transformed material was tested by annealing treatments and characterized by hardness measurements and the variation of the c/a-ratio of the tetragonal gamma-TiAl cell as obtained from X-ray diffraction. After annealing at 1200 degrees C alpha(2)-Ti3Al lamellae appear within the former massively transformed gamma-TiAl grains parallel to all four (111)(gamma)-planes causing an increase in hardness. (c) 2006 Elsevier Ltd. All rights reserved.
Keyword:
titanium alummides
based on TiAl
phase transformations
heat-treatment
microstructure
期刊
IF:
4.8
论文数:
7.0K
被引数:
1.7W
机构
暂无机构信息
引用论文
Structural characterization and tensile properties of a high niobium containing gamma TiAl sheet obtained by powder metallurgical processing
INTERMETALLICS
IF4.8
Creep behaviour and related high temperature microstructural stability of Ti-46Al-9Nb sheet material
INTERMETALLICS
IF4.8
Microstructural refinement in cast TiAl alloys by solid state transformations
SCRIPTA MATERIALIA
IF5.6
Tracer solute diffusion of Nb, Zr, Cr, Fe, and Ni in γ-TiAl:: effect of preferential site occupation
INTERMETALLICS
IF4.8

