返回
High-Efficiency Quad-Mode Parallel PV Power Optimizer for DC Microgrids
DOI:10.1109/TIA.2022.3208879.png)
摘要
En 中文
The paper introduces a new parallel photovoltaic (PV) power optimizer intended for direct integration of PV modules into a dc bus or microgrid. The topology is derived from a typical galvanically isolated buck series resonant dc-dc converter (SRC) to the buck-boost SRC recently proven as a parallel PV power optimizer (PO). By applying the topology morphing control, this two-mode converter is extended to the quad-mode parallel PV PO. Its operation modes defined by changing modulation of switches are detailed, and gain expressions are provided. The proposed concept provides enhanced performance in the region where global power maximum could occur due to partial shading. Accordingly, a significant efficiency improvement is achieved at voltages below the nominal value that targets the most probable PV module operating point without shading. An experimental prototype was built to demonstrate the benefits of the proposed quad-mode PV PO and compare it to the existing two-mode buck-boost SRC. Thermal stress analysis is supported with power loss breakdown calculations to demonstrate component thermal stresses in critical operating points.
Keyword:
Topology
Rectifiers
Microgrids
Voltage
Transformers
MOSFET
DC-DC power converters
Buck-boost
dc microgrid
dc-dc
power optimizer
PV converter
series resonant converter
soft switching
期刊
IF:
4.5
论文数:
1.1W
被引数:
3.5W
机构
引用论文
A simulation-based efficiency comparison of AC and DC power distribution networks in commercial buildings
APPLIED ENERGY
IF11
A High-Efficiency Hybrid Resonant Converter With Wide-Input Regulation for Photovoltaic Applications用于光伏应用的具有宽输入调节的高效混合谐振转换器
On-the-Fly Topology-Morphing Control-Efficiency Optimization Method for LLC Resonant Converters Operating in Wide Input- and/or Output-Voltage Range用于在宽输入和/或输出电压范围内运行的LLC谐振转换器的动态拓扑变形控制效率优化方法

