.png){kind=icon}
返回
Improved Single-Element Resistive Sensor-to-Microcontroller Interface
.png){kind=icon}
PRE
AI
DOI：10.1109/TIM.2017.2712918.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Direct resistive sensor interface to a microcontroller has several advantages but has one prominent disadvantage, namely, the measurement is affected by the resistances of: 1) wires that connect the sensor to the port pins and 2) the internal resistances of the port pins of the microcontroller. A direct sensor-to-microcontroller interface scheme that compensates the effect due not only to resistances of lead wires but also the effect of microcontroller port pin's internal resistance and any offset present in those pins is presented in this paper. Since the resistances of lead wires are compensated, automatic temperature compensation (temperature effect of lead wires) is also obtained. Simulation study and results obtained from a prototype built and tested establish the efficacy of the proposed method. A maximum error of 0.06% was observed from the prototype developed, when it was tested under room temperature, after interfacing it with the sensor Pt100, with a lead wire resistance R-LD = 21 Omega. The error increased to a maximum of 0.08%, when the RLD varied from 0 to 100 Omega. When the same prototype was tested under elevated room temperature of 30 degrees C to 100 degrees C, the maximum error observed was 0.18%.
Keyword:
Direct sensor interface
lead resistance compensation
microcontroller sensor interface
resistive sensors
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
5.9
论文数:
2.0W
被引数:
5.8W
机构
引用论文
A novel lead-wire-resistance compensation technique using two-wire resistance temperature detector.png)
IEEE SENSORS JOURNAL
IEEE SENSORS JOURNALIF4.5
PREAI
分享收藏Relaxation Oscillator-Based Active Bridge Circuit for Linearly Converting Resistance to Frequency of Resistive SensorIEEE SENSORS JOURNAL
IEEE SENSORS JOURNALIF4.5
PREAI
分享收藏
查看更多内容