.png){kind=icon}
返回
Integrated digital image correlation for micro-mechanical parameter identification in multiscale experiments
.png){kind=icon}
OA
AI
DOI：10.1016/j.ijsolstr.2023.112130.png)
.png){kind=icon}
.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Micromechanical constitutive parameters are important for many engineering materials, typically in microelec-tronic applications and material design. Their accurate identification poses a three-fold experimental challenge: (i) deformation of the microstructure is observable only at small scales, requiring SEM or other microscopy techniques; (ii) external loadings are applied at a (larger) engineering or device scale; and (iii) material parameters typically depend on the applied manufacturing process, necessitating measurements on material produced with the same process. In this paper, micromechanical parameter identification in heterogeneous solids is addressed through multiscale experiments combined with Integrated Digital Image Correlation (IDIC) in conjunction with various possible computational homogenization schemes. To this end, some basic concepts underlying multiscale approaches available in the literature are first reviewed, discussing their respective advantages and disadvantages from the computational as well as experimental point of view. A link is made with recently introduced uncoupled methods, which allow for identification of material parameter ratios at the microscale, still lacking a proper normalization. Two multiscale methods are analysed, allowing to bridge the gap between microstructural kinematics and macroscopically measured forces, providing the required normalization. It is shown that an integrated experimental-computational scheme provides relaxed requirements on scale separation. The accuracy and performance of the discussed techniques are analysed by means of virtual experimentation under plane strain and large strain assumptions for unidirectional fibre-reinforced composites. The robustness against image noise is also assessed. The obtained results demonstrate that the expected accuracy is typically within 10% RMS error for all multiscale methods, but decreasing to 1% RMS error for the optimal method.
Keyword:
Integrated digital image correlation
Parameter identification
Multiscale methods
Micromechanics
Inverse methods
Tensile test
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3.8
论文数:
1.2W
被引数:
3.1W
机构
引用论文
Turbocharger motor-generator for improvement of transient performance in an internal combustion engine用于改善内燃机瞬态性能的涡轮增压器电动发电机.png)
Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile EngineeringIF0
PREAI
分享收藏分享收藏
查看更多内容