.png){kind=icon}
返回
Locating initial breakdown pulses using electric field change network
.png){kind=icon}
PRE
AI
DOI：10.1002/jgrd.50441.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Initial breakdown pulses (IBPs) observed in the fast electric field change (E-change) at the beginning of intracloud (IC) and cloud-to-ground (CG) lightning flashes are located using a time-of-arrival technique called Position By Fast Antenna (PBFA) with data from a network of 10 E-change sensors located at Kennedy Space Center. Location errors, estimated using a Monte Carlo method, are usually less than 100 m for horizontal coordinates and several hundreds of meters for altitude, depending on distance to the sensors and altitude of the source. Comparison of PBFA source locations to locations from a VHF lightning mapping system (Lightning Detection and Ranging II (LDAR2)) shows that PBFA locates most of the classic IBPs while LDAR2 locates only a few percent of them. As the flash develops during the IB stage, PBFA and LDAR2 obtain similar locations when they detect the same IBPs. The overall vertical motion indicated by the PBFA positions of IBPs was downward with time for CG flashes and upward with time for IC flashes. Location of the fast pulses due to return strokes of CG flashes is also determined using PBFA. Comparison to locations from the Cloud-to-Ground Lightning Surveillance System (CGLSS) shows that PBFA reliably locates ground strokes. These results are verified using ground truth data acquired with a high-speed video camera. After cross calibration with the CGLSS data set, peak currents of return strokes are also determined.
Keyword:
time of arrival
initial break down pulses
return stroke locations
期刊
J
IF:
3.4
论文数:
2.2W
被引数:
7.7W
机构
引用论文
.png){kind=icon}
分享收藏Online junction temperature monitoring using turn-off delay time for silicon carbide power devices基于关断延迟时间的碳化硅功率器件结温在线监测
PREAI
分享收藏
查看更多内容