返回
Long life elastocaloric regenerator operating under compression
DOI:10.1016/j.applthermaleng.2021.117838.png)
摘要
En 中文
Elastocaloric cooling represents a potentially higher efficiency cooling technique that is also potentially more environmentally friendly than conventional technologies. Elastocaloric devices have now been investigated for some time for this purpose, with materials that are Cu-based, Fe-based or Ni-based. These devices are highly promising, but their main drawback is the lifetime of the devices. A solution could be to activate the devices by compression instead of tension. An active elastocaloric regenerator operating under compression composed of eight NiTi tubes was built and tested in a flow system to evaluate its performance and lifetime. Two regenerator configurations were tested, one with only the NiTi tubes in the regenerator and one with the addition of a flow distributor to improve the thermal exchange between the tubes and the heat transfer fluid. The flow system used was also optimized and modified to reach the best operating conditions. A maximum temperature span of 5 K could be reached by this regenerator and a temperature span of 0.4 K for a cooling power of 1071 W kg- 1. Moreover, under compressive cycling, the regenerator could withstand more than 100 000 cycles without failure.
Keyword:
Elastocaloric materials
Shape memory alloys
Caloric devices
Compression
Regenerator
期刊
IF:
6.9
论文数:
2.8W
被引数:
10.6W
机构
引用论文
Elastocaloric effect in CuAlZn and CuAlMn shape memory alloys under compression压缩下CuAlZn和CuAlMn形状记忆合金的弹性热效应
SMA foil-based elastocaloric cooling: from material behavior to device engineering基于SMA箔的弹性热冷却: 从材料行为到设备工程
On the energy modulation of daytime radiative coolers: A review on infrared emissivity dynamic switch against overcooling
SOLAR ENERGY
IF6.6
A multistage elastocaloric refrigerator and heat pump with 28 K temperature span具有28 K温度跨度的多级弹性热冷机和热泵
SCIENTIFIC REPORTS
IF3.9
Elastocaloric cooling processes: The influence of material strain and strain rate on efficiency and temperature span
APL MATERIALS
IF4.5

