Micromachined polymer-based chemical gas sensor array

F. Zee

doi:10.1016/S0925-4005(00)00638-9

2001-01-01

210

PRE

F. Zee *

Jack W. Judy

DOI：10.1016/S0925-4005(00)00638-9

原文链接

原文求助

摘要

En 中文

We have developed a miniature polymer-based chemical gas sensor array on silicon using micromachining technology. The sensors are polymer-carbon black composite films, which swell reversibly and cause a resistance change upon exposure to a wide variety of gases. We have fabricated two types of devices which can measure this resistance change using a well design. These wells contain the polymer-carbon black-solvent liquid volume present during deposition and allow the sensor him to be placed reproducibly in a specific and well-constrained area. After deposition, the solvents evaporate and leave behind a polymer-carbon black residue crust between metal leads on each side of the well. Two types of devices, a bulk micromachined sensor and a patterned thick-film sensor, have been fabricated, ranging in size from 500 mum x 600 mum to 100 mum x 100 mum. Since the composite him sensors are not specific to any one gas, an array of these sensors, each with a different sensing him, is used to identify gases and gas mixtures through the pattern response of the array Six polymer-carbon black composite films were deposited into the sensor array and exposed to three chemical gases at five different concentration levels. The sensors were able to uniquely detect these gas vapors and demonstrated a linear response to concentration levels between 2000 and 10,000 ppm. Results also indicate that a reduction in sensor area by an order of magnitude (from 4.32 to 0.30 mm(2)) does not reduce sensor response. This design allows the integration of circuits to process the changes in resistance which will permit the realization of a completely integrated miniature gas sensor. (C) 2001 Published by Elsevier Science B.V.

Keyword:

electronic nose

gas sensor

polymer/carbon black

MEMS

SU-8