.png){kind=icon}
返回
Misalignment effect on gearbox failure: An experimental study
.png){kind=icon}
PRE
AI
DOI：10.1016/j.measurement.2020.108492.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Overhang-meshing gears, deflection of pinion/gear shaft, bearing wear, assembly error, poor adjustment of bearings and foundation are the reasons of misalignment in gear drives. In the present work, the misalignment effect on gearbox failure is investigated experimentally using vibration analysis. Misalignment between motor and gearbox is measured using laser alignment system (LAS). The effect of input shaft speed and load on the gearbox failure is also discussed. The misalignment effect primarily observes on the gearbox drive end taper roller bearing and distresses gear transmission. Physical and microscopic examinations of the dismantle gearbox confirm similar findings as observe from vibration spectrum. Severe damages in taper roller bearing (32206) and multiple pits on all the rollers and cone. The bearing cage is deformed badly due to overload and misalignment. The effect of bearing failure on gear's damage is also investigated. Non-uniform contact patch is observed on the meshing gears in the plane of action. Misalignment results in scuffing failure on the pinion addendum and gear dedendum regions due to limited lubricant in the overstress region. At the end of the test, all the four seals appears safe, while the coupling spiders damage seriously.
Keyword:
Vibration
Gear tooth failure
Bearing failure
Misalignment
Taper roller bearing
Wear
Laser alignment system
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
5.6
论文数:
2.0W
被引数:
5.4W
机构
引用论文
Scuffing and lubricant film breakdown in FZG gears Part I. Analytical and experimental approach.png)
WEAR
WEARIF6.1
PREAI
分享收藏
Critical evaluation and comparison of psychoacoustics, acoustics and vibration features for gear fault correlation and classificationMEASUREMENT
MEASUREMENTIF5.6
PREAI
分享收藏
查看更多内容