.png){kind=icon}
返回
NC program evaluator for higher machining productivity
.png){kind=icon}
PRE
AI
DOI：10.1016/S0890-6955(99)00014-0.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
The productivity of machining centers is influenced directly by the quality of NC programs. Conventionally it was effective to calculate machining time based on the values commanded in the NC program. However, as cutting speed/feedrate and machining accuracy increase, more factors have to be considered in the estimation of productivity. In this research, such factors have been found. These are the feed acceleration and average per-block feed distance, besides command feedrate. Furthermore, an effective feedrate factor and a kinematic factor are suggested to express the relations among the above three factors. With the kinematic factor improvements on productivity can be made by changing appropriate parameters in the light of specific conditions. Based on the above analysis, an NC program evaluator was developed to investigate the productivity. With the evaluator, the machining time can be accurately calculated even in high-speed and high-precision machining which is impossible by a conventional CAM tool or an NC controller. Applying the evaluator, three actual NC programs used in high-speed and high-precision cutting were analyzed and the results show that increasing the acceleration and per-block feed distance rather than command feedrate is effective to productivity in high-speed and high-precision cutting. (C) 1999 Elsevier Science Ltd. All rights reserved.
Keyword:
NC program
machining center
productivity
feedrate
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
18.8
论文数:
3.6K
被引数:
1.8W
机构
暂无机构信息
引用论文
The mitochondrial-targeted peptide SBT-20 ameliorates inflammation and oxidative stress in chronic renal failure.png)
Aging
OAAI
AgingIF0
OAAI分享收藏