Non-sequential optimization technique for a computer controlled optical surfacing process using multiple tool influence functions

doi:10.1364/OE.17.021850

Non-sequential optimization technique for a computer controlled optical surfacing process using multiple tool influence functions

2009-12-18

77

OA

AI

DOI：10.1364/OE.17.021850

原文链接

原文求助

摘要

En 中文

Optical surfaces can be accurately figured by computer controlled optical surfacing (CCOS) that uses well characterized sub-diameter polishing tools driven by numerically controlled (NC) machines. The motion of the polishing tool is optimized to vary the dwell time of the polisher on the workpiece according to the desired removal and the calibrated tool influence function (TIF). Operating CCOS with small and very well characterized TIF achieves excellent performance, but it takes a long time. This overall polishing time can be reduced by performing sequential polishing runs that start with large tools and finish with smaller tools. In this paper we present a variation of this technique that uses a set of different size TIFs, but the optimization is performed globally - i.e. simultaneously optimizing the dwell times and tool shapes for the entire set of polishing runs. So the actual polishing runs will be sequential, but the optimization is comprehensive. As the optimization is modified from the classical method to the comprehensive non-sequential algorithm, the performance improvement is significant. For representative polishing runs we show figuring efficiency improvement from similar to 88% to similar to 98% in terms of residual RMS (root-mean-square) surface error and from similar to 47% to similar to 89% in terms of residual RMS slope error. (C) 2009 Optical Society of America

Keyword:

EXTREMELY LARGE TELESCOPE

MIRROR SEGMENTS

FABRICATION

SIMULATION

Non-sequential optimization technique for a computer controlled optical surfacing process using multiple tool influence functions

摘要

期刊

机构

引用论文