.png){kind=icon}
返回
NURBS curve interpolation algorithm based on tool radius compensation method
.png){kind=icon}
PRE
AI
DOI：10.1080/00207543.2015.1062933.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
This paper focuses on developing an algorithm that can generate toolpaths in NURBS form for smooth, high speed and accurate machining. The initial toolpaths are obtained by tool radius compensation method which is based on the workpiece boundary offsetting. According to different lengths and the continuous short block (CSB) criterion, these offset linear segments can be regarded as CSBs or long straight segments. Junctions are located where the curvature value is greater than the preset curvature threshold value or where it changes abruptly, or at the two end points of any long straight segment. During machining, the NURBS fitting module first looks ahead several CSBs and converts them into parametric curves in real time. During the conversion, continuities of the position, slope or even curvature at the transition of the parametric curves and unfitted line segments can be guaranteed. Then the acceleration/deceleration feedrate-planning scheme is proposed to determine the transition feedrate at the junction between the fitted curves and unfitted long straight segments, and the corner feedrate within the fitted curve. Simulations and experiments show that the proposed algorithm can significantly improve machining accuracy and reduce cutting time to satisfy today's high-speed and high-accurate machining requirements.
Keyword:
tool radius compensation
continuous short block
NURBS fitting
look ahead
acceleration
deceleration feedrate-planning
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
7.3
论文数:
1.1W
被引数:
3.7W
机构
引用论文
.png){kind=icon}
Feedrate interpolation with axis jerk constraints on 5-axis NURBS and G1 tool path在5轴NURBS和G1刀具路径上具有轴急动约束的Feedrate插补
OAAI
OAAI分享收藏
查看更多内容