返回
On Frequency-Based Interface Circuits for Capacitive MEMS Accelerometers
DOI:10.3390/mi9100488.png)
摘要
En 中文
Interface circuits for capacitive MEMS accelerometers are conventionally based on charge-based approaches. A promising alternative to these is provided by frequency-based readout techniques that have some unique advantages as well as a few challenges associated with them. This paper addresses these techniques and presents a derivation of the fundamental resolution limits that are imposed on them by phase noise. Starting with an overview of basic operating principles, associated properties and challenges, the discussions then focus on the fundamental trade-offs between noise, power dissipation and signal bandwidth (BW) for the LC-oscillator-based frequency readout and for the conventional charge-based switched-capacitor (SC) readout. Closed-form analytical formulas are derived to facilitate a fair comparison between the two approaches. Benchmarking results indicate that, with the same bandwidth requirement, charge-based readout circuits are more suitable when optimizing for noise performance, while there is still some room for frequency-based techniques when optimizing for power consumption, especially when flicker phase noise can be mitigated.
Keyword:
oscillator
frequency
interface
readout
MEMS
capacitive
accelerometer
noise
power
bandwidth
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3
论文数:
1.4W
被引数:
2.9W
机构
引用论文
Electromechanical Sigma-Delta Modulators (ΣΔM) Force Feedback Interfaces for Capacitive MEMS Inertial Sensors: A Review电容式MEMS惯性传感器的机电sigma-delta调制器 (Σ Δ m) 力反馈接口: 综述
IEEE SENSORS JOURNAL
IF4.5
Application of quantum key distribution in intelligent security operation and maintenance of power communication networks量子密钥分发在智能电力通信网络安全运维中的应用

