.png){kind=icon}
返回
Optimization and Modeling of Angular Deep Drawing Process for Square Cups
.png){kind=icon}
PRE
AI
DOI：10.1080/10426914.2010.532526.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
In this study, an attempt has been made to investigate the effects of die/blank holder angles, blank holder force, and die/punch diameter on the limit drawing ratio, punch force, and minimum wall thickness of DIN EN 10130-1999 steel sheets in angular squared deep drawing process. For this purpose, the die/blank holder profiles were machined 0 degrees, 5 degrees, 10 degrees, and 15 degrees with punch/die diameter of 8, 12, and 16 mm, respectively. A full factorial experimental design method was used for data collection. Regression analysis, signal-to-noise ratio and analysis of variance (ANOVA) were employed to the study to determine the optimal conditions and model the process. The results showed that the deep drawing ratio limits were increased at higher die/blank holder angles and die/punch diameter. The more uniform cup surfaces were observed with lower blank holder forces than standard dies.
Keyword:
Angular deep drawing
Limit drawing ratio
Squared cups
Taguchi method
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
M
IF:
4.7
论文数:
4.6K
被引数:
9.3K
机构
引用论文
.png){kind=icon}
Design and application of blank holder system with spiral spring in deep drawing of square cups
PREAI
分享收藏Clinopyroxene Phenocryst Formation in an Alkaline Magma: Interpretations from Oscillatory Zoning
PREAI
分享收藏
查看更多内容