Optimized multi-floor throughflow micro heat exchangers

Abas Abdoli

doi:10.1016/j.ijthermalsci.2013.12.008

Optimized multi-floor throughflow micro heat exchangers

2014-04-01

9

PRE

AI

A

Abas Abdoli

G

George S. Dulikravich *

DOI：10.1016/j.ijthermalsci.2013.12.008

原文链接

原文求助

摘要

En 中文

Multi-floor networks of straight-through counterflow liquid cooled microchannels have been investigated by performing conjugate heat transfer in a silicon substrate of size 15 x 15 x 1 mm. Two-floor and three-floor cooling configurations were analyzed with different numbers of microchannels on each floor, different diameters of the channels, and different clustering among the floors. Direction of microchannels on each floor changes by 90 degrees from the previous floor. Direction of flow in each microchannel is opposite of the flow direction in its neighbor channels. Conjugate heat transfer analysis was performed by developing a software package which uses quasi-1D thermo-fluid analysis and a fully 3D steady heat conduction analysis. These two solvers are coupled through their common boundaries representing surfaces of the cooling microchannels. Using quasi-1D solver significantly decreases overall computing time and its results are in good agreement with 3D Navier-Stokes equations solver for these types of application. Multi-objective optimization with modeFRONTIER software was performed using response surface approximations and genetic algorithm. Maximizing total amount of heat removed, minimizing coolant pressure drop, minimizing maximum temperature on the hot surface, and minimizing non-uniformity of temperature on the hot surface were four simultaneous objectives of the optimization. Maximum number of cooling microchannels on each floor, diameter ranges of the microchannels on each floor, and vertical clustering range of the floors were the specified constraints. Pareto-optimal solutions demonstrate that thermal loads of 800 W cm(-2) can be effectively managed with such multi-floor microchannel cooling networks. Two-floor microchannel configuration was also simulated with 1000 W cm(-2) uniform thermal load and shown to be feasible. (C) 2013 Elsevier Masson SAS. All rights reserved.

Keyword:

Convection heat transfer

Microchannels

Electronics cooling

High heat flux

Design optimization

Conjugate heat transfer

Optimized multi-floor throughflow micro heat exchangers

摘要

期刊

机构

引用论文