.png){kind=icon}
返回
Parametric Optimization for Selective Surface Modification in EDM Using Taguchi Analysis
.png){kind=icon}
PRE
AI
DOI：10.1080/10426914.2015.1037921.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
This paper introduces selective modification of surface by electric discharge machining process and its parametric optimization. A hard layer of tungsten and copper mixture is created at selected area of aluminum surface. The process is done using W-Cu powder metallurgical green compact tool and masking technique in die-sinking electric discharge machining (EDM). The modified surface is evaluated by the performance measures such as tool wear rate, material transfer rate, surface roughness, and edge deviation from the pre-defined boundary line of deposited layer by analysis of variance using Taguchi design of experiment. Minimum surface roughness of 4.5 mu m and minimum edge deviation of 37.29 mu m is achieved. The hardness of the surface layer is increased more than three times of base metal. Overall effects of parameters are also analyzed considering multiple performance criteria using overall evaluation criteria. The modified surface is characterized using scanning electron microscopy and energy dispersive spectroscopy analysis, which show the tool material transfer at the selected area of the surface.
Keyword:
Deposition
Discharge
Electrical
Machining
Material
Modification
Surface
Selective
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
M
IF:
4.7
论文数:
4.6K
被引数:
9.3K