返回
Performance/structure correlation for composite SOFC cathodes
DOI:10.1016/S0378-7753(96)02361-0.png)
摘要
En 中文
Many solid oxide fuel cell (SOFC) developers use composite electrodes. The cathode is often a mixture of La(Sr)MnO3 and yttria stabilised zirconia (YSZ). Two kinds of cathode structure were studied by means of impedance spectroscopy and d.c. electrochemical methods. The measurements were performed in air at 700-1000 degrees C. Then, the electrode microstructures were examined ceramographically. The cathode performance was improved by increasing the thickness of the composite electrode, and the polarisation resistance was decreased by extending the active triple phase boundary line through the application of a coarse layer of YSZ particles on the electrolyte surface before the composite cathode was applied. The performance proved to be sensitive to structural changes at 700 and 850 degrees C, whereas the effect of the structure was limited at 1000 degrees C. Values as low as 0.07 Omega cm(2) at 1000 degrees C and 0.50 Omega cm(2) at 850 degrees C were obtained in air at an overvoltage of -50 mV. Two simple models relating performance, percolation and triple phase boundary length were used for the interpretation of the results and for assessing the potential for further improvement of the performance by optimising the microstructure.
Keyword:
solid oxide fuel cells
cathodes
lanthanum strontium manganite
yttria stabilised zirconia
structure
performance
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
7.9
论文数:
3.7W
被引数:
18.7W
机构
暂无机构信息
引用论文
Are Complications Less Common in Deep Brain Stimulation than in Ablative Procedures for Movement Disorders?深部脑刺激的并发症比运动障碍的消融手术更不常见吗?
A Nonlinear Least Squares Fit procedure for analysis of immittance data of electrochemical systems用于分析电化学系统的导抗数据的非线性最小二乘拟合程序

