返回
Performance variation with SDC buffer layer thickness
DOI:10.1016/j.ijhydene.2016.04.113.png)
摘要
En 中文
The performance of anode-supported solid oxide fuel cells was investigated as the SDC buffer layer thickness was varied between similar to 0.4 mu m and similar to 2.3 mu m. The thickness of the buffer layer has a significant effect with the peak performance varying in magnitude by a factor of almost three. A peak power density of 1106 mW cm(-2) was achieved at 800 degrees C and an optimal SDC buffer layer thickness of similar to 1.5 mu m. The performance variation was complex due to a balance between ohmic and polarization losses, triple phase boundary area, pin holes and interfacial reactions between the BSCF + SDC cathode, SDC buffer layer, and YSZ electrolyte. Understanding this variation is essential in order to compare two fuel cells having a different porous buffer layer thickness. (C) 2016 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.
Keyword:
Intermediate temperature solid oxide fuel cell
Buffer layer
Interlayer
Anode-supported solid oxide fuel cell
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
8.3
论文数:
5.5W
被引数:
23.1W
机构
引用论文
Enhanced low temperature sintering of (Sr, Cu)-doped lanthanum ferrite SOFC cathodes
SOLID STATE IONICS
IF3.3
Fabrication of an anode-supported yttria-stabilized zirconia thin film for solid-oxide fuel cells via wet powder spraying通过湿法粉末喷涂制备用于固体氧化物燃料电池的阳极支撑的氧化钇稳定的氧化锆薄膜
Cathode electrolyte systems for solid oxide fuel cells fabricated using flame assisted vapour deposition technique
SOLID STATE IONICS
IF3.3
Preparation and performance of solid oxide fuel cells with YSZ/SDC bilayer electrolyteYSZ/SDC双层电解质固体氧化物燃料电池的制备及性能研究
Comparative study of doped ceria thin-film electrolytes prepared by wet powder spraying with powder synthesized via two techniques通过两种技术合成的粉末通过湿法粉末喷涂制备的掺杂氧化铈薄膜电解质的比较研究
Wet powder spraying fabrication and performance optimization of IT-SOFCs with thin-film ScSZ electrolyte含薄膜ScSZ电解质的湿粉喷涂制备及其性能优化

