.png){kind=icon}
返回
Photoelectrocatalytic COD determination method using highly ordered TiO2 nanotube array
.png){kind=icon}
PRE
AI
DOI：10.1016/j.watres.2009.01.035.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
This work focuses on the experimental studies of a photoelectrocatalytic method for COD determination in a thin-cell reactor based on a highly effective TiO2 nanotube array electrode. The effect of preparation parameters on the photoelectrocatalytic performance of TiO2 nanotube array electrodes including the electrolyte, anodic potential, anodic time, solution pH, calcination temperature and time was examined. The TiO2 nanotube array electrode prepared in preparation parameters at 1% HF electrolyte solution, anodic potential 20V, anodic time 5 min, calcination temperature 450 degrees C with highly photoelectrocatalytic performance was chosen as the working electrode. When it is used in a thin-cell photoeletrocatalytic reactor for COD determination, it requires about 1-5 min to complete the oxidation of organics without further titration, much faster than the standard K2Cr2O7 method (2-4 h). It consumes very limited harmless and inexpensive supporting electrolyte, free from secondary pollution. A wide dynamic working range of 0-850 mg/L can be achieved by this method, much wider than any other photoeletrocatalytic methods using TiO2 nanoparticles or nanofilms in the reported literature. The effects of the water components were studied to propose the TiO2 nanotube array method. Real sample analyses were also carried out and the COD value of real samples determined by this method agreed well with the standard dichromate method, and it shows good accuracy, stability and reproducibility. (C) 2009 Elsevier Ltd. All rights reserved.
Keyword:
TiO2 nanotube arrays
Anodization
Chemical oxygen demand (COD)
Photoelectrocatalytic determination
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
