.png){kind=icon}
返回
Power Measurement Using Stockwell Transform
.png){kind=icon}
PRE
AI
DOI：10.1109/TPWRD.2020.3033403.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
The spread of harmonics in electric power systems causes deviations in voltage and current waveforms from the ideal sinusoidal form and, consequently, the traditional power calculation is unsuitable. One of the power theories defined for non-sinusoidal conditions is the IEEE Standard 1459-2010, based on Fourier Transform (FT). However, when applied to non-stationary signals, the FT leads to miscalculation due to spectral leakage, being unsuitable for non-stationary waveforms. In this paper, a new approach for the IEEE Standard 1459-2010 definitions is proposed using Stockwell Transform (ST). The ST provides a time-frequency resolution which retains magnitude and phase information of signals over time. The performance of the proposed method was evaluated in three scenarios including stationary waveforms, a non-linear circuit, and real measured data. The results were compared to the IEEE Standard 1459-2010 using the FT and the Stationary Discrete Wavelet Packet Transform (SDWPT) approaches. In the three scenarios studied, the proposed method presented a good estimation for each quantity defined in IEEE Standard 1459-2010 and provided more accurate results than FT-based and SDWPT-based methods.
Keyword:
Time-frequency analysis
IEEE Standards
Discrete wavelet transforms
Harmonic analysis
Power system harmonics
Power measurement
power quality
non-sinusoidal systems
harmonic distortion
Stockwell transform
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3.7
论文数:
9.1K
被引数:
2.2W
机构
引用论文
.png){kind=icon}
High impedance fault detection based on Stockwell transform and third harmonic current phase angle
PREAI
分享收藏分享收藏
查看更多内容