返回
Retroreflective Transceiver Array Using a Novel Calibration Method Based on Optimum Phase Searching
DOI:10.1109/TIE.2020.2973903.png)
摘要
En 中文
The retrodirective or retroreflective method has been used as a radio-frequency beamforming method for massive antenna array, for wireless communication systems, radars, and microwave power transfer (MPT) systems. In particular, the retroreflective method is suitable for optimum beamforming for both near- and far-field zones. Each transmitter (Tx) and receiver (Rx) circuit in the Tx array has its own phase offset, which should be calibrated for optimum retroreflective operation. This article presents a simple and effective phase offset calibration method for the retroreflective beamforming arrays using a one-by-one basis optimum phase searching method with a receiver at a reference point. To verify the proposed calibration method for a massive retroreflective beamforming array, a 5.2 GHz short- and mid-range (<= 4 m) MPT system, including a Tx array based on 8 x 8 antennas and an Rx using six antennas (five rectennas for power reception, and 1 additional for pilot transmission) for charging mobile handsets was designed and implemented. Optimal retroreflective beamforming from the Tx array, which was calibrated using the proposed method, was experimentally verified for elevation angles of within +/- 45 degrees for both xz- and yz-planes. The implemented Tx and Rx circuits achieved a received dc power of about 100 mW at a distance of 4 m.
Keyword:
Microwave power transfer
phased array calibration
retrodirective
retroreflective
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
7.2
论文数:
1.8W
被引数:
9.8W
机构
引用论文
Energy-Efficient and Adaptive Design for Wireless Power Transfer in Electric Vehicles电动汽车无线电能传输的节能自适应设计

