返回
Robust convolution kernel quantity determination based on corner radiation area adaptation
DOI:10.1016/j.neucom.2018.07.054.png)
摘要
En 中文
The number of kernels in a convolutional neural network (CNN) can have a significant impact on the performance of the CNN in the aspects of accuracy and computation efficiency. However, existing approaches to determining the number of convolution kernels are mainly conducted through a manual process, which suffers from the problems of potential overfitting, instability and inefficiency. In response to these problems, this paper presents a corner radiation area adaptation (CRAA) based method to automatically determine the number of convolution kernels. CRAA is evaluated in comparison with three representative methods on multiple public data sets. Experimental results show that CRAA is robust to the number of convolution kernels which is well adapted to a specific data set and achieves a higher level of classification accuracy by 3% when spending the same period of time in classification. More importantly, CRAA reduces the computational time by 15% in comparison with the three representative approaches when reaching the same level of accuracy in classification. (C) 2018 Elsevier B.V. All rights reserved.
Keyword:
Convolutional kernel
Convolutional neural network
Feature extraction
Corner radiation area adaptation
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
6.5
论文数:
2.5W
被引数:
6.5W
机构
引用论文
State estimation under false data injection attacks: Security analysis and system protection虚假数据注入攻击下的状态估计: 安全分析与系统防护
AUTOMATICA
IF5.9
Noise robust image edge detection based upon the automatic anisotropic Gaussian kernels
PATTERN RECOGNITION
IF7.6
Gradient-based learning applied to document recognition基于梯度的学习在文档识别中的应用
PROCEEDINGS OF THE IEEE
IF25.9
Stability analysis for discrete-time stochastic memristive neural networks with both leakage and probabilistic delays具有泄漏和概率时滞的离散随机忆阻神经网络的稳定性分析
NEURAL NETWORKS
IF6.3
An Experimental Study on Machining of AISI H - 13 Steel Using Dimple-Textured and Non-Textured Tungsten Carbide Cutting Tools关于使用凹坑纹理和非纹理碳化钨切削刀具加工AISI H-13钢的实验研究

