Second-order improved refined plastic hinge method with implementation of continuous strength method

Yi Zhou

doi:10.1016/j.jcsr.2023.108169

2023-12-01

PRE

DOI：10.1016/j.jcsr.2023.108169

原文链接

原文求助

摘要

En 中文

Stainless steel, aluminium alloy, and cold-formed steel structures have been increasingly used as the main load-bearing components in civil engineering. However, owing to the rounded stress-strain response of the materials with significant strain hardening, the traditional plastic hinge model based on elastic-perfect plastic material response is not applicable, and the strength reduction of slender cross-sections by local buckling is also not considered. This paper proposed an improved refined plastic hinge method that can apply to different materials and fully consider the strain hardening and local buckling effect. A beam-column element was proposed, in which the second-order effect between axial load and bending moment was incorporated in the stiffness matrix formulation by using the approximate sixth-order polynomial function. The continuous strength method was introduced to the refined plastic hinge model to consider the strain hardening effect of non-slender and the local buckling effect of slender cross-sections by controlling the strength and deformability of the sections. Combining the elastic and plastic limit state criteria, the stiffness degradation function for SHS and RHS was obtained. The accuracy and efficiency of the proposed method were verified by the experimental results for stainless steel, aluminium alloy, and cold-formed steel columns of SHS and RHS under axial and eccentric compression. Finally, the proposed method was used for the design of frames for the materials, the results indicated that it was an effective tool that was ready for design practice.

Keyword:

Second-order inelastic analysis

Strain limits

Beam-column element

Refined plastic hinge

Metal frames