.png){kind=icon}
返回
Selection of solidification pathway in rapid solidification processes
.png){kind=icon}
PRE
AI
DOI：10.1103/PhysRevMaterials.7.023403.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Rapid solidification processing of alloys enables the formation of exotic nonequilibrium microstructures. However, the interrelationship between the processing parameters and the resulting microstructure is yet to be fully understood. In melt spinning (MS) and additive manufacturing (AM) of rapidly solidified alloys, opposite microstructure development sequences were observed. A fine-to-coarse microstructural transition is typically observed in melt-spun ribbons, whereas melt pools in AM exhibit a coarse-to-fine transition. In this paper, the microstructural evolutions during these two processes are investigated using phase-field modeling. The variation of all key variables of the solid-liquid interface (temperature, composition, and velocity) throughout the entire rapid solidification of AM and MS processes was acquired with high accuracy. It is found that the onset of nucleation determines the selection of the solidification pathway and, consequently, the evolution of temperature and velocity of the interface during the rapid solidification. The switching of control mechanisms of the solid-liquid interface, which happens in both processes but in opposite directions, is found to cause the velocity jump and disrupt the microstructure development.
Keyword:
PHASE-FIELD MODEL
MECHANICAL-PROPERTIES
GROWTH-KINETICS
MICROSTRUCTURE
ALLOYS
ALUMINUM
TRANSITIONS
SIMULATION
PREDICTION
DIFFUSION
期刊
IF:
3.4
论文数:
5.2K
被引数:
1.7W
机构
引用论文
Real-time monitoring of laser powder bed fusion process using high-speed X-ray imaging and diffraction.png)
SCIENTIFIC REPORTS
OAAI
SCIENTIFIC REPORTSIF3.9
OAAI分享收藏Effect of Zirconium addition on crack, microstructure and mechanical behavior of selective laser melted Al-Cu-Mg alloySCRIPTA MATERIALIA
SCRIPTA MATERIALIAIF5.6
PREAI
分享收藏Composition and automated crystal orientation mapping of rapid solidification products in hypoeutectic Al-4 at.%Cu alloys亚共晶Al-4中快速凝固产物的组成和自动晶体取向映射。% Cu合金ACTA MATERIALIAOAAI
ACTA MATERIALIAIF9.3
OAAI分享收藏Microstructure and mechanical properties of Al-Mg-Zr alloys processed by selective laser melting选区激光熔化al-mg-zr合金的显微组织和力学性能ACTA MATERIALIAOAAI
ACTA MATERIALIAIF9.3
OAAI分享收藏
查看更多内容