返回
SPS driven lithium differential diffusion in NASICON-like structures
DOI:10.1016/j.bsecv.2015.11.005.png)
摘要
En 中文
Samples of nominal composition Li1.3Fe0.3Ti1.7(PO4)(3) with a NASICON-type crystal structure, can be sintered up to 95% of the theoretical density at only 600 degrees C using spark plasma sintering, SPS. The final pellets however show different colouration in their upper and lower faces, being the upper face white and the lower one pink. The analysis of both surfaces by XPS shows a higher concentration of lithium on the white upper face, as a consequence of the polar diffusion of ions from the positive to the negative rams during SPS. On the other hand the study by XRD and SEM shows the formation of an extra phase in the upper face with nominal composition LiOPO4. A change in the cell parameters of the original NASICON structure is also observed, confirming the diffusion of lithium ions. (C) 2015 SECV. Published by Elsevier Espana, S.L.U.
Keyword:
Batteries
NASICON structure
Spark plasma sintering
Microstructure
XPS
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
B
IF:
2.7
论文数:
80
被引数:
1.0K
机构
引用论文
Polyvinyl pyrrolidone/Mg(ClO4)2 solid polymer electrolyte: structural and electrical studies
Ionics
IF0
Dependence of ionic conductivity on composition of fast ionic conductors Li1+xTi2-xAlx(PO4)3, 0 ≤ x ≤ 0.7.: A parallel NMR and electric impedance study离子电导率对快离子导体Li1 xTi2-xAlx(PO4)3,0 ≤ x ≤ 0.7组成的依赖性: 并行NMR和电阻抗研究
Influence of chromium content on the optical and electrical properties of Li1+xCrxTi2-x(PO4)3铬含量对Li1 xCrxTi2-x(PO4)3光电性能的影响
SOLID STATE IONICS
IF3.3

