.png){kind=icon}
返回
Tool path generation for triangular meshes using least-squares conformal map
.png){kind=icon}
PRE
AI
DOI：10.1080/00207543.2010.492409.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
Tool path generation is an interesting and challenging task in free-form surface machining. Iso-planar tool path generation is one of the common approaches to dealing with this task. However, it suffers from an inherent drawback that intersecting intervals of the iso-planar method are limited to surface geometric features. This results in poor machining efficiency in flat regions due to redundant machining paths. For this problem, a new tool path generation method for triangular meshes is proposed based on the least-squares conformal map (LSCM). After LSCM parameterisation with minimal stretching energy, the triangular meshes are unfolded on a plane, where the principal component analysis (PCA) technique is employed to determine a suitable drive line for calculating cutter contact paths by the iso-planar strategy. Therefore, the tool paths are generated in a plane and the unevenness of the traditional iso-planar method is improved. The feasibility and effectiveness of the developed method is demonstrated through a test experiment.
Keyword:
tool path generation
triangular meshes
least-squares conformal map
iso-planar method
free-form surfaces
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
7.3
论文数:
1.1W
被引数:
3.7W
机构
引用论文
.png){kind=icon}
分享收藏
查看更多内容