Tool-path generation from measured data

doi:10.1016/S0010-4485(02)00070-2

2003-04-01

PRE

Sang Chan Park *

Yun‐Chan Chung

DOI：10.1016/S0010-4485(02)00070-2

原文链接

原文求助

摘要

En 中文

Presented in the paper is a procedure through which 3-axis NC tool-paths (for roughing and finishing) can be directly generated from measured data (a set of point sequence curves). The rough machining is performed by machining volumes of material in a slice-by-slice manner. To generate the roughing tool-path, it is essential to extract the machining regions (contour curves and their inclusion relationships) from each slice. For the machining region extraction, we employ the boundary extraction algorithm suggested by Park and Choi (Comput.-Aided Des. 33 (2001) 571). By making use of the boundary extraction algorithm, it is possible to extract the machining regions with O(n) time complexity, where n is the number of runs. The finishing tool-path can be obtained by defining a series of curves on the CL (cutter location) surface. However, calculating the CL-surface of the measured data involves time-consuming computations, such as swept volume modeling of an inverse tool and Boolean operations between polygonal volumes. To avoid these computational difficulties, we develop an algorithm to calculate the finishing tool-path based on well-known 2D geometric algorithms; such as 2D curve offsetting and polygonal chain intersection algorithms. (C) 2002 Elsevier Science Ltd. All rights reserved.

Keyword:

NC machining

tool-path

measured data

swept volume

rapid prototyping

reverse engineering