Cavitation control using passive flow control techniques

Mahshid Zaresharif

doi:10.1063/5.0071781

Cavitation control using passive flow control techniques

2021-12-16

43

OA

AI

DOI：10.1063/5.0071781

Original

Original request for help

Save

Abstract

En 中文

Passive flow control techniques, and particularly vortex generators have been used successfully in a broad range of aero- and hydrodynamics applications to alter the characteristics of boundary layer separation. This study aims to review how such techniques can mitigate the extent and impact of cavitation in incompressible flows. This review focuses first on vortex generators to characterize key physical principles. It then considers the complete range of passive flow control technologies, including surface conditioning and roughness, geometry modification, grooves, discharge, injection, obstacles, vortex generators, and bubble generators. The passive flow control techniques reviewed typically delay and suppress boundary layer separation by decreasing the pressure gradient at the separation point. The literature also identifies streamwise vortices that result in the transfer of momentum from the free stream to near-wall low energy flow regions. The area of interest concerns hydraulic machinery, whose performance and life span are particularly susceptible to cavitation. The impact on performance includes a reduction in efficiency and fluctuations in discharge pressure and flow, while cavitation can greatly increase wear of bearings, wearing rings, seals, and impeller surfaces due to excessive vibration and surface erosion. In that context, few studies have also shown the positive effects that passive controls can have on the hydraulic performance of centrifugal pumps, such as total head and efficiency. It is conceivable that a new generation of design in hydraulic systems may be possible if simple design features can be conceived to maximize power transfer and minimize losses and cavitation. There are still, however, significant research gaps in understanding a range of impact factors such as manufacturing processes, lifetime, and durability, and essentially how a static design can be optimized to deliver improved performance over a realistic range of operating conditions. (c) 2021 Author(s). All article content, except where otherwise noted, is licensed under a Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).

Keywords:

LAMINAR SEPARATION BUBBLE

LEADING-EDGE

VORTEX GENERATORS

BOUNDARY-LAYER

ATTACHED CAVITATION

WIND TURBINE

PERFORMANCE IMPROVEMENT

SHEET CAVITATION

WALL ROUGHNESS

DRAG REDUCTION

Cavitation control using passive flow control techniques

Abstract

Journal

Organization

Cited Papers