.png){kind=icon}
Return
Enhanced cooling for LED lighting using ionic wind
.png){kind=icon}
PRE
AI
DOI：10.1016/j.ijheatmasstransfer.2012.10.015.png)
.png){kind=icon}
Original request for help.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
This study employs ionic wind to augment heat transfer of a LED mounted on a substrate. The size of the LED chip is 0.9 mm x 0.9 mm with a nominal power of 1 W. A needle type electrode is used to generate ionic wind with the applied voltage ranging from 4 to 11 kV. The effects of aligned angle, electrode polarity, separation distance, and ground configuration on the thermal resistance of the LED substrate are examined in this study. For the same applied voltage, it appears that the thermal resistance for the negative polarity is lower than that for the positive one and the negative electrode also has a wilder operation range. The thermal resistance can be reduced as much as 50% in the test range. The thermal resistance is slightly reduced when the aligned angle is increased from 0 degrees to 20 degrees, but a further increase of aligned angle casts no further reduction on the thermal resistance. It is found that the influence of vertical separation distance between the needle and ground electrode is moderately higher than that of horizontal separation distance. Test results also indicate that the mesh ground electrode shows moderately lower thermal resistance than those of point or line electrode. (C) 2012 Elsevier Ltd. All rights reserved.
Keywords:
Electrohydrodynamics
Ionic wind
LED
Natural convection
AI Summary
Key information extracted from the uploaded paper, including a brief overview, abstract, background, key highlights, visual analysis, and future outlook.
Journal
IF:
5.8
Papers:
2.6W
Citations:
10.2W
Organization
Cited Papers
.png){kind=icon}
ShareSave
ShareSave
ShareSave
View more