.png){kind=icon}
Return
Gear-box fault detection using time-frequency based methods
.png){kind=icon}
PRE
AI
DOI：10.1016/j.arcontrol.2015.09.004.png)
.png){kind=icon}
.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
Gear-box fault monitoring and detection is important for optimization of power generation and availability of wind turbines. The current industrial approach is to use condition monitoring systems, which runs in parallel with the wind turbine control system, using expensive additional sensors. An alternative would be to use the existing measurements which are normally available for the wind turbine control system. The usage of these sensors instead would cut down the cost of the wind turbine by not using additional sensors. One of these available measurements is the generator speed, in which changes in the gear-box resonance frequency can be detected. Two different time-frequency based approaches are presented in this paper. One is a filter based approach and the other is based on a Karhunen-Loeve basis. Both of them detect the gear-box fault with an acceptable detection delay of maximum 100s, which is neglectable compared with the fault developing time. (C) 2015 International Federation of Automatic Control. Published by Elsevier Ltd. All rights reserved.
Keywords:
Wind turbines
Wind turbine gear-box
Fault detection
Karhunen-Loeve basis
Journal
IF:
10.7
Papers:
836
Citations:
5.9K
Organization
Cited Papers
Adaptive feedforward compensation algorithms for active vibration control with mechanical coupling.png)
AUTOMATICA
OAAI
AUTOMATICAIF5.9
OAAIShareSave
Practical aspects of a condition monitoring system for a wind turbine with emphasis on its design, system architecture, testing and installationRENEWABLE ENERGY
RENEWABLE ENERGYIF9.1
PREAI
ShareSave
View more