.png){kind=icon}
.png){kind=icon}
Return
High discharge capacity solid composite polymer electrolyte lithium battery
.png){kind=icon}
PRE
AI
DOI：10.1016/j.jpowsour.2010.11.058.png)
.png){kind=icon}
Original request for help.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
In this study, a series of nanocomposite polymer electrolytes (CPEs). PAN/LiClO4/SAP, with high conductivity are prepared based on polyacrylonitrile (PAN), LiClO4 and low content of the silica aerogel powder (SAP) prepared by the sol-gel method with ionic liquid (IL) as the template. The effect of addition of SAP on the properties of the CPEs is investigated by FTIR, AC impedance, linear sweep voltagrams and cyclic voltammetry measurements as well as the charge-discharge performance. It is found that the ionic conductivity of the CPE is significantly improved by addition of SAP. The maximum ambient ionic conductivity of CPEs is about 12.5 times higher than that without addition of SAP. The results of the voltammetry measurements of CPE-3, which contained 3 wt% of SAP, show that the anodic and cathodic peaks are well maintained after 100 cycles, showing excellent electrochemical stability and cyclability over the potential range between 0 V and 4V vs. Li/Li+. Besides, the room temperature discharge capacity measured at 0.5C for the coin cell based on CPE-3 is 120 mAh g(-1) and the capacity is retained after 20 cycles discharge, indicating the potential for practical use. This is perhaps the first report of the room temperature charge-discharge performance on the solid composite polymer electrolyte to the best of our knowledge. (C) 2010 Elsevier B.V. All rights reserved.
Keywords:
Solid composite polymer electrolyte
Silica aerogel
Discharge capacity
Ionic conductivity
Lithium battery
AI Summary
Key information extracted from the uploaded paper, including a brief overview, abstract, background, key highlights, visual analysis, and future outlook.
Journal
IF:
7.9
Papers:
3.7W
Citations:
15.0W