.png){kind=icon}
.png){kind=icon}
Return
.png){kind=icon}
.png){kind=icon}
.png){kind=icon}
.png){kind=icon}
.png){kind=icon}
Abstract
En 中文
Hydroxyapatite (HA) was coated onto a titanium (Ti) substrate with the insertion of a titania (TiO2) buffer layer by the sol-gel method. The HA layer was employed to enhance the bioactivity and osteoconductivity of the Ti substrate, and the TiO2 buffer layer was inserted to improve the bonding strength between the HA layer and Ti substrate, as well as to prevent the corrosion of the Ti substrate. The HA layer coated over the TiO2 showed a typical apatite phase at 400degreesC and the phase intensity increased above 450degreesC. The sol-gel derived HA and TiO2 films, With thicknesses of approximately 800 and 200 nm, respectively, adhered tightly to each other and to the Ti substrate. The bonding strength of the HA/TiO2 double layer coating on Ti was markedly improved when compared to that of the HA single coating on Ti. The highest strength of the double layer coating was 55 MPa after heat treatment at 500degreesC. The improvement in bonding strength with the insertion of TiO2 was attributed to the resulting enhanced chemical affinity of TiO2 toward the HA layer, as well as toward the Ti substrate. Human osteoblast-like cells, cultured on the HA/TiO2 coating surface, proliferated in a similar manner to those on the TiO2 single coating and on the pure Ti surfaces. However, the alkaline phosphatase activity of the cells on the HA/TiO2 double layer was expressed to a higher degree than that on the TiO2 single coating and pure Ti surfaces. The corrosion resistance of Ti was improved by the presence of the TiO2 coating, as confirmed by a potentiodynamic polarization test. (C) 2003 Elsevier Ltd. All rights reserved.
Keywords:
hydroxyapatite coating
titania buffer layer
titanium substrate
sol-gel method
bonding strength
cell response
corrosion resistance
Journal
IF:
12.9
Papers:
1.9W
Citations:
10.8W
Organization
No organization information available