.png){kind=icon}
.png){kind=icon}
Return
Modelling gear contact with twin-disc setup
.png){kind=icon}
PRE
AI
DOI：10.1016/j.triboint.2011.12.007.png)
.png){kind=icon}
Original request for help.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
Efficiency of polymer/steel gear-drive depends on friction phenomenon. Earlier research on polymer/steel gears identifies that region close to pitch-point has uncertain behaviour until a maximum of 30% slip due to the abrupt change from pure rolling to sliding. Calculation and testing methodology were developed for NaPA6/steel pairs. Influence of speed on friction-force was studied, where established boundaries are found at 170 rpm, above which the frictional-force depends on velocity and increases linearly. A high influence on rate sensitivity for polymer deformation at low velocity confirms the rapid increase in friction-force at low speeds. The threshold recommends for efficient performance as a function of speed for gear-drive during running-in before the formation of transfer layer. (C) 2011 Elsevier Ltd. All rights reserved.
Keywords:
Sliding
Rolling
Polymer-metal contact
Spur gear
Journal
IF:
6.9
Papers:
1.1W
Citations:
4.2W