.png){kind=icon}
Return
Multiobjective Optimization for Dual Active Bridge Converter Under Variable-Frequency Single-Phase-Shift Modulation
.png){kind=icon}
PRE
AI
DOI：10.1109/TPEL.2025.3617657.png)
.png){kind=icon}
Original request for help.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
The dual active bridge (DAB) converter serves as a dc transformer in high-power applications. Efficiency and power density are significant optimization objectives for DAB converters, influenced by factors such as modulation strategy, converter parameter, magnetic components design, etc. Variable-frequency (VF) single-phase-shift (SPS) modulation has been employed to improve light load efficiency, which is suitable in scenarios where the input and output bus voltages remain constant. However, under this modulation strategy, converter parameters and magnetic components have received little optimization. This article presents a multiobjective optimization method for DAB converter under VF SPS modulation. To ensure rated power and light-load zero-voltage-switching (ZVS), the design range of inductance and switching frequency is determined while considering nonidealities. Pareto optimization is applied for magnetic components design under the specific modulation strategy, balancing efficiency and power density. Finally, the switching frequency is optimized under different loads for high efficiency. A 6.4 kW DAB prototype is developed for experiment, verifying the multiobjective optimization is reasonable. Compared with traditional SPS modulation, the measured efficiency of optimized VF SPS modulation increases by 1.7% and 1.2% under full load and 20% load conditions, respectively, proving the effectiveness of the proposed optimization method.
Keywords:
Dual active bridge (DAB)
magnetic component
multiobjective optimization
variable-frequency (VF) modulation
zero-voltage-switching (ZVS)
Journal
IF:
6.5
Papers:
1.7W
Citations:
8.3W
Organization
Cited Papers
No cited papers available